TOMAHAWK® T7600-S 12V Cordless Drill Set | 28 Nm | 2-Speed | 1.5Ah Battery | Carry Case

• 12V CORDLESS POWER: No cable to run, no extension board and no socket to find, so the same drill works on a terrace, in a half-built site with no supply yet, or in the back of a vehicle. Pick it up, press the trigger, work.
• 28 NM OF TORQUE: Torque is turning force - it is what drives a long screw fully home into hard wood or a wall plug instead of stopping halfway and stripping the head.
• 18+1 TORQUE SETTINGS: Turn the collar down for a small screw in a cabinet hinge and up for a coach screw in a rafter. The clutch slips before it over-drives, which is what stops you splitting the wood or snapping the screw head clean off.
• 350/1350 RPM: Two things happen here: high speed drills clean holes without burning the bit, low speed drives screws without wrecking the head.
• 2 GEARBOX: Low gear gives you the grunt for big screws and masonry; high gear gives you the speed for drilling. It is a mechanical change, not an electronic one, so you keep full power in both.
• 10MM (⅜”) KEYLESS CHUCK: Change a bit with one hand in a couple of seconds - no chuck key to lose, which is the single most common reason a drill sits unused in a toolbox.
• DRILLS STEEL: 8-10MM, WOOD: 16-20MM, PLASTIC: 65MM (USING HOLE SAW) - The honest limit of what this machine will go through. Buying a drill that is under-specified for the material is how motors get burnt out in the first month.
• 1.5 AH X 1 BATTERY PACK: Amp-hours are simply how long it runs before charging. The pack slides off without tools, so a spare swaps in within seconds. It charges from any ordinary wall socket - no special supply needed.

• 1 × T7600-S cordless drill machine
• 1 × 12V 1.5Ah battery
• 1 × charger
• 1 × flexible shaft
• 4 × drill bits
• Socket set (9 pcs)
• 1 × socket adapter
• Screwdriver bits (9 pcs)
• 1 × 8mm hex head socket adapter
• 1 × carry case
• User manual

Six months against manufacturing defects, from the date of purchase.

Service is handled in India. Genuine spare parts are stocked, so a worn part does not end the tool.

Contact care@tomahawk.tools or call +91 99300 90896, Monday to Saturday.