TOMAHAWK® TNP-125 Nipper Cutter | 125 mm | Flush Cut | Cuts up to 1.5 mm

• SHARP FLUSH CUTTING, NOT CRUSHING: the ground edges meet flat against the board so a component lead is cut level with the solder joint instead of being pinched and left proud.
• 125MM, SIZED FOR CLOSE WORK: short enough to get between components on a populated board and light enough to hold all day without your hand tiring.
• FULLY HARDENED STEEL EDGES: the cutting edges are hardened through rather than just surface treated, so they keep their bite through thousands of cuts instead of rolling over after a few hundred.
• SOFT SPRING ACTION OPENS IT FOR YOU: the spring returns the jaws after every cut, so you squeeze and release rather than squeeze and prise open.
• ONE-HAND OPERATION: cut with one hand while the other holds the board, the wire or the work steady.
• CUTS UP TO 1.5MM: sized for soft copper wire, component leads, cable ties, plastic sprue and fine craft wire.
• BUILT FOR ELECTRONICS AND HOBBY WORK: PCB assembly and repair, jewellery making, model and RC building, fishing rigs, plastic trimming and cable management. Anywhere the cut has to be clean and close rather than merely quick.
• DOUBLE DIPPED ANTI-SLIP HANDLE: the soft outer grip stays put in a warm hand and spreads the squeeze across the palm rather than concentrating it on two edges.

• 1 × TNP-125 nipper cutter

Six months against manufacturing defects, from the date of purchase.

Service is handled in India. Genuine spare parts are stocked, so a worn part does not end the tool.

Contact care@tomahawk.tools or call +91 99300 90896, Monday to Saturday.